1.S3C2440中斷初始化：

#define BIT_ALLMSK(0xffffffff)

void Isr_Init(void)
{
pISR_UNDEF=(unsigned)HaltUndef;
pISR_SWI =(unsigned)HaltSwi;
pISR_PABORT=(unsigned)HaltPabort;
pISR_DABORT=(unsigned)HaltDabort;
rINTMOD=0x0; //All=IRQ mode Address:0x4A000004 =1FIQ mode; =0 IRQ mode
rINTMSK=BIT_ALLMSK;// All interrupt is masked. Address:0x4A000008 0 = Interrupt service is available.
//1 = Interrupt service is masked.
}
void HaltUndef(void)
{
Uart_Printf("Undefined instruction exception!!!n");
while(1);
}

void HaltSwi(void)
{
Uart_Printf("SWI exception!!!n");
while(1);
}

void HaltPabort(void)
{
Uart_Printf("Pabort exception!!!n");
while(1);
}

void HaltDabort(void)
{
Uart_Printf("Dabort exception!!!n");
while(1);
}

2. 7個中斷地址：

#define _ISR_STARTADDRESS 0x33ffff00

#define pISR_RESET(*(unsigned *)(_ISR_STARTADDRESS+0x0))
#define pISR_UNDEF(*(unsigned *)(_ISR_STARTADDRESS+0x4))
#define pISR_SWI(*(unsigned *)(_ISR_STARTADDRESS+0x8))
#define pISR_PABORT(*(unsigned *)(_ISR_STARTADDRESS+0xc))
#define pISR_DABORT(*(unsigned *)(_ISR_STARTADDRESS+0x10))
#define pISR_RESERVED(*(unsigned *)(_ISR_STARTADDRESS+0x14))
#define pISR_IRQ(*(unsigned *)(_ISR_STARTADDRESS+0x18))
#define pISR_FIQ(*(unsigned *)(_ISR_STARTADDRESS+0x1c))

(unsigned*)目的把(_ISR_STARTADDRESS+0x0)指針強轉(unsigned*)類型，最前的一個*，取該(unsigned*)類型指針對應的unsigned值；
得惡補C語言的知識了