***************************
TMR0用作定時器時，定時器時鐘＝系統時鐘/4；
寫TMR0時，會產生2個周期的的延時，如果不使用前置分頻器，可通過設置
初值進行補償。
例如 需要定時200個時鐘周期時，TMR0 = 256 -200 + 2= 58

OPTION_REG:

bit5 T0CS:TMR0 Clock Source Select bit

1 = Transition on T0CKI pin

0 = Internal instruction cycle clock(CLKO)

bit 4 T0SE:TMR0 Source Edge Select bit

1 = Increment on high-to-low transition on T0CKI pin

0 = Increment on low-to-high transition on T0CKI pin

bit 3 PSA:Prescaler Assignment bit

1 = Prescaler is assigned to the WDT

0 = Prescaler is assigned to the Timer0 module

bit2-0 PS2:PS0:Prescaler Rate Select bits

給大家一個意見：如果想用TMR0實現精確的定時，一旦用了預分頻器后就不要對TMR0做任何寫操作。

注意：在中斷服務程序中查詢TMR0中斷時，既要查詢T0IE位，還要查詢T0IF位。
***********************/
#include
#include "../head/config.h"

__CONFIG(HS&WDTDIS&LVPDIS&PWRTEN);
//HS振蕩,禁止看門狗,低壓編程關閉,啟動延時定時器

uint16 count = 0;
void main(void)
{
PSA = 1;//prescaler is assigned to the WDT
T0CS = 0;//Internal instruction cycle clock

TMR0 = 58;//timer 200 cycle clock

GIE = 1;//global interrupt enable
T0IE = 1;//TMR0 interrupt enable

PORTD = 0x00;
TRISD = 0x00;

while(1)
{}
}

void interrupt ISR(void)
{
if(T0IE && T0IF)
{
T0IF = 0;
count++;
if(count == 1000)
{
count = 0;
PORTD = ~PORTD;
}
TMR0 = TMR0 + 58;
}
}